[FadeMan]

It will be nice if anybodu could help me. I don't know if this is serious problem. But when I draw in photoshop and I use wacom graphire then when I make some faster move the line is not so nice smooth, for example when I want to draw circle it doesn't look like circle , it has a lot of edges. But when I try this in Fractal design painter it is ok. I don't understand it. Might it be that it is a fault of the wacom driver. Thank you , any help will help me.

------------------

[faustgfx]

double click the brush and set the spacing to 1% ?

uncheck 'size' ?

fuck around with your wacom driver's firmness setting?

pray?



------------------
http://www.faustgfx.com
icq#35983387
the resident caustic bitch / the owls are not what they seem.

[osk]

Hmm dont know what to tell ya there buddy , you might want to check .. what DPI you are opening your new documents as .. shouldn't be less than 100 . but that shouldn't be the problem .. It couldn't be resolution either if Painter works fine .. hmm it might just be the sttings on it . you can try going into the control panel for the WACOM tablet .. and set some specific settings just for photoshop .. because there is a way to set the pen differently for every program so that it recognizes how to act on certain programs like Photoshop ..
sorry this might not be very helpfull but is all i can think of .

[Ko]

Hi there

This is a well known problem with Photoshop.
It has been discussed a few times before on this forum.

Intuos USB tablets behave the same way.
There's nothing you can do about, it's a problem with Photoshop's brush-engine.

Painter's brush tracking system is much better than Photoshop's and can properly handle smooth curves when drawing fast.

Ko