[Giant Hamster]

...I have a 9x12 tablet and my screen Resolution is at 1024x768.

when i first installed it, it was working fine. it had no problems.
i turned off my computer that night, and when i got on the next morning i tried to draw, and it would only cover 800x600 of my screen....thats a lot smaller!!

the normal mouse still works, but my tablet acts as though my resolution is at 800x600. and its also drawing about 2 inches up and 2 inches left of the actual cursor... this all happened overnight!!! grrr...

thanks

------------------
-JameZ the Giant Hamster-
the Hamster Alliance
www.mp3.com/jamezthegh
ICQ: 43691064
Musician,2d/3d artist, programmer,overall guru :)

[jfraker]

My Intos did the same thing, all I did was download the new drivers and installed them, it worked fine after that.

[Blind]

I don't know if this will help you, but I had a similar problem. I switched to 1280�1024 rez from 1024�768 on my desktop AFTER my Wacom 6�8 was installed, and I noticed it was only covering the old rez's screen area. The Wacom doesn't seem to notice screen rez changes on some systems after installation.

What I did, was go into the tablet properties and under the Mapping tab, there's an Advanced Mapping button. In there, you can manually set the screen area, tablet area, etc. That might do it. It seems the Wacom needs to sometimes be told when a screen rez change has been made.

BTW, I use version 4.20 of the tablet drivers, because I lost pressure sensitivity in PS 5.5 with 4.30 & 4.40. Weird... don't know why. Maybe 4.50 will work? >8\

Good luck...